Perfect storm 2.0 instructions

IMPORTANT!!!

TIGHTEN THE TWO EXISTING DECK SCREWS HOLDING THE CENTER BOX BEFORE INSTALLING THE 2.0! MAKE THEM AS TIGHT AS A WAVESTORM WOULD BE,

  1. Use fin key included in the Perfect storm fin kit and remove middle and side fins from surfboard.

  2. Using the fin key back the two Allen screws out of the center fin box until they are not blocking the slots for the new fin tabs.

  3. Holding the fin key in one hand use the free hand to Install Perfect storm 2.0 fin in center fin box. Use as much pressure as necessary to push the perfect storm fin flush to the bottom of the surfboard.

  4. While holding the fin tight to the board, tighten set screws with Allen key through the access holes located on each side of the 2.0 fin.

If fin is still not flush to the board

  • Tighten the black deck screws more.

  • Repeat steps 3-4

 

hold in the critical parts of a larger wave. It will

however reduce the turning performance. If you have

installed the Perfect Storm fin and used the front screw

as directed and would like to switch it back to the

stock set up. Just remove the middle fin and the front

screw, cover the screw hole with a small piece of clear

packing tape. If the tape is cut in the shape of a circle,

it will hold up to the elements much better. Probably for

the life of the board.